Required reserves
Calculate the minimum amount of money the bank must hold in cash from your deposit 2750 Eur.
How much money is ideally created in the banking system from your deposit if the level of minimum reserve requirement is 2.15%?
Consider fractional reserve system, i.e., your bank can defer from your deposit reserve requirement (PMR), give the rest of the loan, which will again deposit money and thus flow system, etc., etc.
Today, PMR is 2% in the euro area, the U.S. at 10%, and China at 17%.
What is the cash multiplier, the ratio between the generated money and your deposit from which it originated?
How much money is ideally created in the banking system from your deposit if the level of minimum reserve requirement is 2.15%?
Consider fractional reserve system, i.e., your bank can defer from your deposit reserve requirement (PMR), give the rest of the loan, which will again deposit money and thus flow system, etc., etc.
Today, PMR is 2% in the euro area, the U.S. at 10%, and China at 17%.
What is the cash multiplier, the ratio between the generated money and your deposit from which it originated?
Correct answer:
Tips for related online calculators
Need help calculating sum, simplifying, or multiplying fractions? Try our fraction calculator.
Our percentage calculator will help you quickly calculate various typical tasks with percentages.
Check out our ratio calculator.
Our percentage calculator will help you quickly calculate various typical tasks with percentages.
Check out our ratio calculator.
You need to know the following knowledge to solve this word math problem:
Units of physical quantities:
Grade of the word problem:
Related math problems and questions:
- Pump power
Determine the pump power if: I pour 3 m³ of water from the tank in 120 seconds with a hose. The height of the hose mouth above the tank is 1.5 m. The water's speed from the hose outlet is 20 m/s. - Temperature 7477
The pool with a length of l = 50 m and a width of s = 15 m has a depth of h1 = 1.2 m at the shallowest part of the wall. The depth then gradually increases to a depth of h2 = 1.5 m in the middle of the pool. = 4.5 m walls in the deepest part of the pool. - Orlík hydroelectric plant
The Orlík hydroelectric power plant, built in 1954-1961, consists of four Kaplan turbines. For each of them, the water with a flow rate of Q = 150 m3/s is supplied with a flow rate of h = 70.5 m at full power. a) What is the total installed pow - What power 2
What power has a pump output to move 4853 hl of water to a height of 31 m for 8 hours? Comparing the power generated by the pump vs. the power generated by the motor, which is more efficient? Which pump or motor generates more pollution if, for every watt - Radiators
Calculate the radiator output if it has a thermal gradient (difference between inlet water and return temperatures) a) 5°C b) 10°C c) 15°C d) 20°C A heating water volume flow is 45 kg/h. How fast the water flows from the supply pipe to the radiator e) DN1 - Concrete column
The concrete column of the highway bridge has the shape of a block with dimensions of 1m x 0.8m x 25m. Crane should lift it to a height of 20m. What is the power of his engine if the lifting takes 2 minutes? - Pump
What power does a pump output to move 4853 hl of water to a height of 31 m for 8 hours? - Cu thief
The thief stole 142 meters copper wire with a cross-section area of $s mm². Calculate how much money gets in the scrap redemption if redeemed copper for 5.3 Eur/kg. The density of copper is 8.96 t/m³. - Acceleration 79164
A skier goes down a slope 66 m long in a uniformly accelerated motion in 10 seconds. With what acceleration was it moving, and what is the slope of the slope? - Approximately 30131
Please calculate according to Pascal's law. Calculate the hydrostatic pressure at a depth of 300m below sea level if the density of seawater is approximately 1025kg per m³. At what depth below the surface is the hydrostatic pressure 4.5 MPa? - Compressive 19933
The submarine is at a depth of 50 m below the concave surface of the sea. Find the hydrostatic compressive strength of seawater on a metal cover with an area of 0.6 m². - A car
A car weighing 1.05 tonnes driving at the maximum allowed speed in the village (50 km/h) hit a solid concrete bulkhead. Calculate height would have to fall on the concrete surface to make the impact intensity the same as in the first case! - Copper sheet
The copper plate has a length of 2.2 m, width 92 cm, and weighs 5.6 kg. What is the plate thickness if 1 m³ weighs 8732 kg? - Complete 16
Complete the conversions below, show calculations and answers 1) 3.5 kg to gram 2) 4567ml to litres 3) R45.78 to cent 4) 5.60m to centimeters - Heat energy
Energy is measured using the unit Joule (J). Temperature is measured using the unit degree Celsius °C). To increase the temperature of 1 liter of water by 1°C, 4200 J of heat energy is required. (a) Kelly wants to increase the temperature of 2 liters of w - Coefficient 81094
A car moves along a horizontal road at a speed of 15 m/s. After turning off the engine, the car traveled a distance of 225 m. What was the coefficient of friction for this motion? - Cross-sectional 80979
An undisciplined motorcyclist drove at an unreasonable speed on a mountain road, lost control in a bend, and left the roadway at 90 km/h. He was falling into a gully 36 m deep. Draw a cross-sectional picture of the whole situation. How far did the motorcy