Sphere
The sphere's surface is 12100 cm2, and the weight is 136 kg. What is its density?
Correct answer:
Tips for related online calculators
Do you want to convert length units?
Do you know the volume and unit volume, and want to convert volume units?
Tip: Our Density units converter will help you convert density units.
Do you want to convert mass units?
Do you know the volume and unit volume, and want to convert volume units?
Tip: Our Density units converter will help you convert density units.
Do you want to convert mass units?
You need to know the following knowledge to solve this word math problem:
Units of physical quantities:
Grade of the word problem:
Related math problems and questions:
- Determine 69154
Determine the pump power if: I pour 3 m³ of water from the tank in 120 seconds with a hose. The height of the hose mouth above the tank is 1.5 m. The water's speed from the hose outlet is 20 m/s. - Temperature 7477
The pool with a length of l = 50 m and a width of s = 15 m has a depth of h1 = 1.2 m at the shallowest part of the wall. The depth then gradually increases to a depth of h2 = 1.5 m in the middle of the pool. = 4.5 m walls in the deepest part of the pool. - Orlík hydroelectric plant
The Orlík hydroelectric power plant, built in 1954-1961, consists of four Kaplan turbines. For each of them, the water with a flow rate of Q = 150 m3/s is supplied with a flow rate of h = 70.5 m at full power. a) What is the total installed pow - What power 2
What power has a pump output to move 4853 hl of water to a height of 31 m for 8 hours? Comparing the power generated by the pump vs. the power generated by the motor, which is more efficient? Which pump or motor generates more pollution if, for every watt - Pump
What power does a pump output to move 4853 hl of water to a height of 31 m for 8 hours? - Cu thief
The thief stole 142 meters copper wire with a cross-section area of $s mm². Calculate how much money gets in the scrap redemption if redeemed copper for 5.3 Eur/kg. The density of copper is 8.96 t/m³. - Radiators
Calculate the radiator output if it has a thermal gradient (difference between inlet water and return temperatures) a) 5°C b) 10°C c) 15°C d) 20°C A heating water volume flow is 45 kg/h. How fast the water flows from the supply pipe to the radiator e) DN1 - Concrete column
The concrete column of the highway bridge has the shape of a block with dimensions of 1m x 0.8m x 25m. Crane should lift it to a height of 20m. What is the power of his engine if the lifting takes 2 minutes? - Complete 16
Complete the conversions below, show calculations and answers 1) 3.5 kg to gram 2) 4567ml to litres 3) R45.78 to cent 4) 5.60m to centimeters - Energy 5
Energy is measured using the unit Joule (J). Temperature is measured using the unit degree Celsius °C). To increase the temperature of 1 liter of water by 1°C, 4200 J of heat energy is required. (a) Kelly wants to increase the temperature of 2 liters of w - Acceleration 79164
A skier goes down a slope 66 m long in a uniformly accelerated motion in 10 seconds. With what acceleration was it moving, and what is the slope of the slope? - Increases 69454
The car weighs 1850 kg and increases its speed from 27 to 81 km/h. How much has its kinetic energy increased? - Power consumption
The price of electricity is ₱6.50 per kilowatt hour (kWh). How much electricity was consumed if a television with 120 W power consumption ran from 7:30 AM to 12:30 PM? How much will this cost? - The train
The train starts for 2 min with an acceleration of 25 cm/s². What speed will he gain in this time, and what path will he pass? - Aluminum cylinder
The aluminum cylinder weighs 1400 g and is 26 cm high. Its density is 2700 kg/m³. Calculate the base area of the cylinder and express the result in cm². - There
There is 5 l of water with a temperature of 20°C in the bucket. We add 3 liters of hot water. The resulting temperature will be 30°C. What was the temperature of the hot water? - Heat transfer
We placed a lead object weighing 0.4 kg and 250°C in 0.4 L water. What was the initial temperature of water t2 if the object's temperature and the water after reaching equilibrium was 35°C? We assume that the heat exchange occurred only between the lead o