Decibel
A circuit has an input power of 92 mW. Its output power is 12 mW. What is the loss in decibels?
Correct answer:
Tips for related online calculators
Check out our ratio calculator.
You need to know the following knowledge to solve this word math problem:
Units of physical quantities:
Themes, topics:
Grade of the word problem:
Related math problems and questions:
- Heat energy
Energy is measured using the unit Joule (J). Temperature is measured using the unit degree Celsius °C). To increase the temperature of 1 liter of water by 1°C, 4200 J of heat energy is required. (a) Kelly wants to increase the temperature of 2 liters of w - What power 2
What power has a pump output to move 4853 hl of water to a height of 31 m for 8 hours? Comparing the power generated by the pump vs. the power generated by the motor, which is more efficient? Which pump or motor generates more pollution if, for every watt - Power during takeoff
The aircraft weighing 3.5 tons will disembark 1 km in 1 minute after takeoff and reach a speed of 290 km/h. Find the average power of its engines during this time. - Pump power
Determine the pump power if: I pour 3 m³ of water from the tank in 120 seconds with a hose. The height of the hose mouth above the tank is 1.5 m. The water's speed from the hose outlet is 20 m/s.
- Fuel efficiency
The gravimetric analysis of an anthracite fuel is 90% carbon, 3% hydrogen, 2% oxygen, and 1% nitrogen. Given that analysis of the dry combustion products by volume is 16.2% CO2, 3.5% O2, and 80.3% N2, during the combustion process of anthracite, which con - The output
The output voltage of the transformer is 880 V. The secondary coil has 1200 turns. Transformation ratio k = 4. Find the voltage to which the primary coil is connected. How many turns does the primary coil have if a current of 1 A flows through it? What cu - Free fall
The elevator car weighing 720 kg, is torn off at the height of 125 m and begins to fall in a free fall. How much kinetic energy did the elevator car have when it hit the ground floor of the building when the free fall of the car lasted 5 s? - Electric cooker
During which time, does an electric cooker with power input P = 500 W and with efficiency n = 75% heat water with mass m = 2 kg and temperature t1 = 10°C to the boiling point (t2 = 100°C). The specific heat capacity of water is c = 4 180 J. Kg-1. K-1 - Concrete column
The concrete column of the highway bridge has the shape of a block with dimensions of 1m x 0.8m x 25m. Crane should lift it to a height of 20m. What is the power of his engine if the lifting takes 2 minutes?
- Motorcycle engine
The motorcycle engine has a constant power of 1.2 kW for 0.5 hours. How much work does the engine do? Express work in kWh and Ws units. - Electric work
Calculate the work done by the electric forces passing the current of 0.2 A through the bulb in 10 minutes if the bulb is connected to a 230 V power supply. - Power input
The construction lift lifted a load weighing 300 kg to a height of 12 m with a uniform movement. How long has it taken for the load to be lifted if the efficiency is 75% and the engine has a power input of 5 kW? - Temperature 7595
Colorless liquid weighing m = 200 g is heated with constant stirring on a stove with power input P0 = 600W. 80% of the supplied energy is used to heat the liquid. Selected measured values of liquid temperature as a function of time are recorded in the t - Orlík hydroelectric plant
The Orlík hydroelectric power plant, built in 1954-1961, consists of four Kaplan turbines. For each of them, the water with a flow rate of Q = 150 m3/s is supplied with a flow rate of h = 70.5 m at full power. a) What is the total installed pow
- Consumption 6581
We heated water weighing 1 kg at 70 degrees in a kettle. C. In 5 min. What is the power consumption of the kettle? We do not take into account losses or boiling points. - The appliance
The appliance has a power input of 2.3 kW. It is connected to the mains voltage of 230 V. What is the current flowing through the appliance? - Efficiency
What is the power output of a kettle 2 kW with an efficiency of 90%?