# Cube corners

From cube of edge 14 cm cut off all vertices so that each cutting plane intersects the edges 1 cm from the nearest vertice.

How many edges will have this body?

Result

n =  36

#### Solution:

Leave us a comment of example and its solution (i.e. if it is still somewhat unclear...):

Be the first to comment!

## Next similar examples:

1. Concentric circles
There is given a circle K with a radius r = 8 cm. How large must a radius have a smaller concentric circle that divides the circle K into two parts with the same area?
2. Probability of intersection
Three students have a probability of 0.7,0.5 and 0.4 to graduated from university respectively. What is the probability that at least one of them will be graduated?
3. Former price
The price of an article is cut by 10℅, to restore it to the former value, by what percent the new price must be increased?
4. Diamond and diagonals
A diamond has diagonals f = 8 cm and g = 6 cm long. How long is this diamond perimeter? (Calculate it!)
5. Castle tower
The castle tower has a cone-shaped roof with a diameter of 10 meters and a height of 8 meters. Calculate how much m² of coverage is needed to cover it if we must add one-third for the overlap.
6. The diagram 2
The diagram shows a cone with slant height 10.5cm. If the curved surface area of the cone is 115.5 cm2. Calculate correct to 3 significant figures: *Base Radius *Height *Volume of the cone
7. Curiosity factor
A blogger starts a new website, initially the number of the traffic is 293 due to their curiosity factor. The business owner estimated that the traffic will increase by 2,6% per week. What will be the number of it in week 5?.
8. Sphere floating
Will float a hollow iron ball with an outer diameter d1 = 20cm and an inside diameter d2 = 19cm in the water? The iron density is 7.8 g/cm 3. (Instructions: Calculate the average sphere density and compare with the density of the water. )
9. Banknotes
How many different ways can the cashier payout € 310 if he uses only 50 and 20 euro banknotes? Find all solutions.
10. Lathe
95% of the components manufactured on the lathe comply with the standard, of which 80% of the components are first-class. How likely can we expect a manufactured part to be first class?
11. Percent change
If the length of a rectangle is increased by 25% and the width is decreased by 10%, the area of the rectangle is larger than the area of the original rectangle by what percent?