Feed rate
The feed rate of a drill is the distance it advances with each revolution. If a drill makes 320 rpm and drills a hole 2.625 inches deep in 1.8 minutes, what is the feed rate?
Final Answer:
Tips for related online calculators
Do you want to convert length units?
Do you want to convert velocity (speed) units?
Do you want to convert time units like minutes to seconds?
Do you want to convert velocity (speed) units?
Do you want to convert time units like minutes to seconds?
You need to know the following knowledge to solve this word math problem:
Units of physical quantitiesthemes, topicsGrade of the word problem
Related math problems and questions:
- Seed drills
The tractor driver connected two seed drills behind the tractor and sowed 7 ha of grain in 5 hours. How many hectares did he plant in 8 hours the next day if he connected three seed drills? - Drill bit
Bill's 3/8-inch drill bit is missing and needed for a job. He can get by with drilling a smaller hole than 3/8-inch as long as it is as close to 3/8-inch as possible. Which of the following bits would be the best to use? A. 13/32 inch B. 23/64 inch C. 1/2 - RPM
An electric motor makes 3,000 revolutions per minute. How many degrees does it rotate in one second? - A bakery
A bakery makes cylindrical mini muffins that measure 2 inches in diameter and one-fourth inches in height. If each mini muffin is completely wrapped in paper, how much paper is needed to wrap 6 mini muffins? Approximate using pi equals 22 over 7. - Walkers
Walker, which makes 120 steps per minute, makes the distance from point A to point B 55 minutes. The length of his step is 75cm. How long does this distance go, a boy who will do 110 steps 60 cm long in a minute? - Total displacement
Calculate the total displacement of the 12-cylinder engine with the diameter of the piston bore B = 8.9 cm and stroke S=1.9 cm of the piston. Help: The crankshaft makes one revolution while the piston moves from the top of the cylinder to the bottom and b - Triangle revolution volume
What is the hole volume drilled by the drill in the shape of a right triangle that revolves around a longer perpendicular? The perpendiculars of the triangle are 10 cm and 3 cm long.
