Electrical engineering - high school - practice problems - page 2 of 4
Number of problems found: 72
- Conductor 66234
For how long does a charge of 600 C pass through the conductor at a current of 1 A.? - Manganin
How long must a manganin wire with a diameter of 0.8 mm have a value of 10Ω? - The coil 2
The coil of a moving coil voltmeter is 40 mm long and 30 mm wide and has 100 turns on it. The control spring exerts a torque of 240 x 10-6 N-m when the deflection is 100 divisions on a full scale if the flux density of the magnetic field in the air gap is - Serial resistors
In the circuit shown ( two resistors, R1 and R2 serial connected), the total resistance from A to B is 16 ohms. Find the resistance R2 and the current through the R1 = 12-Ohm resistor if the voltage between A and B is 10 V.
- Isosceles 48443
Three equal positive charges Q are located at the vertices of an isosceles right triangle ABC. The right angle is at vertex A. The length of side AB is 1m. What is the electric field strength at the center S of side BC, i.e., what force would act on a pos - Three resistors
You must connect three identical resistors with 12 Ohm resistances to get the resulting resistance gradually) 36 Ohm, b) 4 Ohm and 18 Ohm. Draw a diagram of each circuit. - Individual 46993
We measured the voltage U= 75 V between the circuit's external terminals with a voltmeter. The circuit's resistance values of the individual resistors (in series) are 50 Ohm and 100 Ohm. Find out what voltage we would measure on the 1st and 2nd resistor - Resistance 46111
A metal ring with a radius of 10 cm is placed in a magnetic field so that the normal to its surface makes an angle of 60° with the induction lines. The induction of the magnetic field varies uniformly and drops from 0.45 T to 0.35 T in 0.50 s. Determine t - Cylindrical 46021
Calculate the magnetic field energy of a cylindrical coil with 400 turns, a length of 0.4 m, and a radius of 20 mm. A current of 3A passes through the coil. (µo = 4π 10-7 H. M-1)
- Self-inductance 46011
Calculate the self-inductance of the coil, which has 1,300 turns, if the inductive current through the coil changes by 6 * 10 ^ -5 Wb by a constant current change of 2A. - Performance 45861
The electric motor with a power input of 25 kW works with an efficiency of 80 percent. He will do the work in 6 hours. What is the performance, and what part of the work is the loss? - Transmission 44701
The electric field performs work 1610 J in the transmission of electric charge of 7 Coulombs between the heating coil terminals. Calculate the voltage between the terminals. - The output
The output voltage of the transformer is 880 V. The secondary coil has 1200 turns. Transformation ratio k = 4. Find the voltage to which the primary coil is connected. How many turns does the primary coil have if a current of 1 A flows through it? What cu - The transformer
The transformer's primary coil has 1100 turns and is connected to a voltage of 220 V. How many turns does the secondary coil have when it has a voltage of 55 V? Determine the transformation ratio and decide what the transformation is.
- Separated 38223
What is the intensity of the electric field at a point that lies in the middle between two point charges Q1 = 5.10-5 C and Q2 = 7.10-5 C, which is separated by r = 20 cm? The charges are placed in a vacuum. - Copper winding
Calculate the current flowing through the copper winding at an operating temperature of 70°C Celsius if the winding diameter is 1.128 mm and the coiled length is 40 m. The winding is connected to 8V. - Temperature 34641
The aluminum line has a resistance of 7.6Ω at -10˚C. What will be its resistance at a temperature of + 50˚C? - RC time constant
You introduced 1 Coulomb worth of electrons into the inner volume of a dielectric material with ϵr=6. Thirty minutes later, you found that only 36.79% of the electrons were in the internal volume. Determine the conductivity σ of the dielectric material. - Maxwell’s inductance bridge
The four arms of Maxwell's inductance bridge are; Arm AB contains an Inductive coil of inductance L1 having resistance R1. Arms BC and CD contain non-inductive resistances of 200Ω and 100Ω, respectively. Arm AD contains a standard inductor of inductance L
Do you have homework that you need help solving? Ask a question, and we will try to solve it.