Planimetrics + fundamentals of Physics - practice problems - page 2 of 5
Number of problems found: 95
- Circumference 7209
The speed of the points lying on the circumference of the rotating disk is 6 m/s. The speed of the points, which lie 20 cm closer to the axis of rotation, is 4 m/s. Find the angular velocity of the wheel. - Diver
Please calculate using Pascal's law. The window of the diving helmet has a surface area of about 7dm². Calculate what pressure force acts on the window at a depth of 20 meters below the water surface. - Steering 49363
The steering wheel has a diameter of 40 cm. It is acted upon by a pair of forces with a torque of 27 Newton-meters. How much force does it exert on each side of the steering wheel? - Horizontal 6365
The tank's weight is 36 t, and the total contact area of the belts with the ground is 4 square meters. What pressure does the tank cause on a horizontal surface?
- Physics - pressure
Find the pressure exerted by a crawler tractor of mass 30 t standing on a flat road if the area of the contact surface of the belts with the ground is 6 m square. - Peripheral 82517
Calculate the peripheral speed of the number on the Wheel of Fortune if the wheel rotates within a period of 0.25 seconds and the number is written 1.5 m from the center of the wheel. - Hydraulic 36041
The large piston of the hydraulic system has a capacity of 0.25 m² and a small 10 cm². How much force do we exert on the small piston to be lifted by 750 N? - On a
On a someday, the Sun, Venus, and the Earth are in eclipse, i. E. Venus is between the Sun and the Earth. Venus orbits the Sun in 225 days. In how many years will all three bodies be in alignment again? - Concerning 7000
Some points are at rest in a moving railway car concerning the earth's surface. However, some points move in the opposite direction to the direction of the moving car's speed. Which points are they?
- Centimeters 6366
The weight of the pupil and the chair is 52 kg. The area of the contact surfaces of the chair with the floor is 12 square centimeters. What pressure does the chair put on the floor? - Circular motion
The mass point regularly moves in a circle with radius r = $r m angular velocity ω = 4.3 rad/s. Calculate the period, frequency, and centripetal acceleration of this movement. - Constant Angular Acceleration
The particle began to move from rest along a circle with a constant angular acceleration. After five cycles (n = 5), its angular velocity reached the value ω = 12 rad/s. Calculate the magnitude of the angular acceleration ε of this motion and the time int - RPM
An electric motor makes 3,000 revolutions per minute. How many degrees does it rotate in one second? - Tarzan
Tarzan, weighing m = 90 kg, tries to cross the river by swinging with a vine hanging from a tree leaning over the river. Liana has a length l = 12 m. The speed of the Tarzan in the lowest swing position is v = 8 m/s. Tarzan doesn't know that the liana wil
- Inclined plane
1. How much work W do we have to do to pull a body weighing 200 kg along an inclined plane with a length of 4 m to a total height of 1.5 m? 2. Find the force we need to exert to do this if we neglect frictional resistance. 3. Find the force we would need - Resistivity 3983
What was the length of an iron wire with an area of 3cm² if its resistance was 15 ohms? Iron (Fe) resistivity is 0.0996 x 10 at -6 Ohm/meter. - Cylindrical 81748
The hydrostatic pressure at the bottom of a cylindrical water container is 10 kPa. The bottom has an area of 0.25m². How much pressure does the water exert on the bottom? - Coefficient 45821
What is the smallest radius a turn must-have for a car to enter safely without exceeding a speed of 50 km / h? The coefficient of shear friction between the tires and the surface is 0.4. - Single-reverse 78404
Hydraulic jack has a capacity of 10 tons. The hydraulic lifter has 6 cm² and 360 cm² pistons. Determine the diameter of the small piston (d) and the force I will create on the piston (F). Design a single-reverse and a double-reverse lever.
Do you have homework that you need help solving? Ask a question, and we will try to solve it.